^NN – Set SNMP

What ^NN does

^NN is part of the Network Commands reference. Use it when working with set snmp on compatible Zebra printers. This independent reference focuses on the command shape, configuration inputs, defaults, and the surrounding commands that are commonly used with it.

Syntax

^NNa,b,c,d,e,f

Parameter quick reference

• a = system name Same as printer name.
• Values: Up to 17 alphanumeric characters
• b = system contact Any contact information as desired (such as a name or phrase)
• Values: Up to 50 alphanumeric characters
• c = system location The printer’s model information.
• Values: Up to 50 alphanumeric characters
• d = get community name Values: Up to 19 alphanumeric characters
• Default: public
• e = set community
• Values: Up to 19 alphanumeric characters

Implementation guidance

• Confirm that the printer model and firmware support the command before deployment.
• Test the smallest valid command first, then add optional parameters one at a time.
• Keep units in printer dots unless the command explicitly defines another unit.
• Verify the result on the target media, because resolution, orientation, and stored settings can change the output.

Troubleshooting

If the printer ignores the instruction, check the command prefix, delimiter characters, firmware support, and whether the command belongs inside a ^XA and ^XZ format. For output commands, also confirm that the field is closed with ^FS where required.

Source note

This independently written page was checked against the Zebra programming guide revision supplied for this project (reference page 385). Zebra, ZPL, and related product names are trademarks of their respective owners.