^TO – Transfer Object

What ^TO does

^TO is part of the Graphics, Formats, and Memory reference. Use it when working with transfer object on compatible Zebra printers. This independent reference focuses on the command shape, configuration inputs, defaults, and the surrounding commands that are commonly used with it.

Syntax

^TOs:o.x,d:o.x

Parameter quick reference

• s = source device of
• Values: R:, E:, B:, and A:
• Default: if a drive is not specified, all objects are transferred to the drive set
• o = stored object name Values: any existing object conforming to Zebra conventions
• Default: if a name is not specified, * is used — all objects are selected
• x = extension Values: any extension conforming to Zebra conventions
• Default: if an extension is not specified, * is used — all extensions are
• d = destination device of
• Values: R:, E:, B:, and A:
• Default: a destination must be specified

Implementation guidance

• Confirm that the printer model and firmware support the command before deployment.
• Test the smallest valid command first, then add optional parameters one at a time.
• Keep units in printer dots unless the command explicitly defines another unit.
• Verify the result on the target media, because resolution, orientation, and stored settings can change the output.

Troubleshooting

If the printer ignores the instruction, check the command prefix, delimiter characters, firmware support, and whether the command belongs inside a ^XA and ^XZ format. For output commands, also confirm that the field is closed with ^FS where required.

Source note

This independently written page was checked against the Zebra programming guide revision supplied for this project (reference page 357). Zebra, ZPL, and related product names are trademarks of their respective owners.