power.battery_led_blink_rate SGD Reference
What power.battery_led_blink_rate does
power.battery_led_blink_rate is part of the SGD Printer Settings reference. Use it when working with power battery led blink rate on compatible Zebra printers. This independent reference focuses on the command shape, configuration inputs, defaults, and the surrounding commands that are commonly used with it.
Syntax
! U1 setvar "power.battery_led_blink_rate" "value"Parameter quick reference
On Duration = 2 (2 * 0.5 = 1 second), see power.battery_led_on_duration on page 951Off Duration = 9 (9 * 0.5 = 4.5 seconds), see power.battery_led_off_duration on page 950Blink Rate = 2 (2 * 0.5 = 1 second)
Implementation guidance
- Confirm that the printer model and firmware support the command before deployment.
- Test the smallest valid command first, then add optional parameters one at a time.
- Keep units in printer dots unless the command explicitly defines another unit.
- Verify the result on the target media, because resolution, orientation, and stored settings can change the output.
Troubleshooting
If the printer ignores the instruction, check the command prefix, delimiter characters, firmware support, and whether the command belongs inside a ^XA and ^XZ format. For output commands, also confirm that the field is closed with ^FS where required.
Source note
This independently written page was checked against the Zebra programming guide revision supplied for this project (reference page 948). Zebra, ZPL, and related product names are trademarks of their respective owners.